| |
|
  Download Brochure
|
Guardall In-Floor Safes
• Model GUAD fitted with a lagard 33E 6 digit touch pad powered by one 9V alkaline battery
• Model GUAC fitted with S & G wheel 1 million change combination
• Model GUAK fitted with a six lever pick resistant key lock
• Spring assisted door pivot
• Removal doors interchange to facilitate service and installation
• Flush fitting lid to aid concealment and fire protection
• Hard plate to protect lock area
• Emergency relocking device
The safes may be installed in either concrete or timber floors. The opening in the floor should be at least 500mm square by 500mm deep.
The safe should be secured with a strong mix concrete 1 x sand, 1 x stone, 1 x cement. Steel reinforcing material can also be used to help bond the concrete and provide better security.
It is recommended that the mix be poured so that a concrete cover of at least 100mm (4'') exists around each side of the safe and brought level with top.
|
| |
Floor safes are not waterproof. In damp situations the concrete should contain a waterproofing agent such as "Silasec" or "Yurite" (available from hardware stores). Whilst the concrete is setting, the door should be removed.
Recommended overnight cash holding for all models $10,000.
|
| |
| |
| |
| |
 Download Brochure
|
Collector In-Floor Safe
• 20mm thick steel door plate
• Heavy-duty boltwork with rack and pinion
• Body reinforced with steel gussets in corners
• Gas-ram to assist lifting of door
• Combination lock (1,000,000 differs) on
hardened steel mounting plate
• Re-locking devices
• Heavy duty clip-on lid (dust cover) to
form part of floor surface
Suitable installation into timber or concrete floors
Recommended overnight cash holding $25,000.
|
 |
^ top
Available in 2 sizes
Download Brochure
|
Austral In-Floor Safe |
Standard features include:-
DOOR: Heavy cast high-tensile steel
construction fully chromium plated. Door
section is secured below 25mm thick steel
top plate. Special hinge is to move heavy
door only and is not part of security.
LOCKING: 1 million change combination
lock mounted on hardened steel, drill
resistant plate.
Two spring loaded relocking devices
incorporated in door and lock.
BODY: Heavy gauge steel with 25mm thick
steel top plate machined to accept door
with minimum of tolerance.
HINGES: Hinged door for ease of operation.
(Doors are interchangeable).
LID: Heavy steel lid,
fits flush with top of safe.
Deposit chute may be fitted if required.
Recommended overnight cash holding for all models $20,000.
|
|
 Download Brochure
|
Secure-All Security In-Floor Safe
• Flush fitting lid to aid concealment and fire protection
• Interchangeable door (8kg) secured by 3 wheel S&G combination lock
• Clear 155mm access to contents storage area 265 x (280 x 280)
Recommended overnight cash holding for SECA $30,000.
|
|
Available in 4 sizes
Download Brochure
|
Mark I Torch And Drill Resisting
• One million change keyless combination lock
• Large door opening 178mm x 127mm (7" x 5") on hinged door model. 254mm x 127mm (10" x 5") on lift-out door model
• Suitable for mounting in floor
• Proven resistance to drilling, oxy-acetylene cutting and explosives
• Relocking devices incorporated in door
• Boltwork activated by Rack & Pinion mechanism preventing pening problems often associated with ordinary floor safes
Recommended overnight cash holding for TDR $40,000.
|
|
|
|
|
